Remington LNT-2 Manuel D'utilisation Et D'entretien page 13

OPERATING CHAIN
SAW
Continued
Normal Guide Bar Maintenance
1. Remove guide bar from chain saw.
2. Remove sawdust from guide bar
groove periodically. Use putty knife or
wire.
3. Clean oil slots after each day of use.
4. Remove burrs from sides of guide bar.
Use flat file to make side edges square.
Replace guide bar when
• bar is bent or cracked
• inside groove of bar is badly worn
When replacing guide bar, see Re-
Note:
placement Parts, page 14 for proper bar.
Cleaning Groove
With Putty Knife
Oil Slot
Figure 18 - Guide Bar Maintenance
SHARPENING YOUR SAW
CHAIN
WARNING: Unplug chain saw
WARNING ICON G 001
from power source before servic-
ing. Severe injury or death could
occur from electrical shock or
body contact with moving chain.
WARNING: Cutting edges on
WARNING ICON G 001
chain are sharp. Use protective
gloves when handling chain.
100583
Keep chain sharp. Your saw will cut faster
and more safely. A dull chain will cause
undue sprocket, guide bar, chain, and motor
wear. If you must force chain into wood and
cutting creates only sawdust with few large
chips, chain is dull.
Items Needed to Sharpen Chain
Purchase these items from your local dealer,
hardware store, or chain saw supplies outlet.
• 4 mm (5/32") round file
• File guide
• Medium sized flat file
• Depth gauge too
• Vise
Sharpening Cutters
Use file guide for 30° filing.
1. Adjust chain for proper tension (see Saw
Chain Tension Adjustment, page 8).
Flat File
Burr
2. Clamp guide bar in vise to hold saw
steady.
3. Press four millimeter (5/32") round file
(attached to file guide) into groove be-
tween top plate and depth gauge on chain.
File guide should rest on both top plate
and depth gauge (see Figures 19 and 20).
Note:
4. Hold file guide level. Make sure 30°
Guide
mark on file guide is parallel to center
Bar
of guide bar (see Figure 19). This will
insure that you file cutters at 30° angle.
5. File from inside towards outside of cut-
ter until sharp. Only file in this one direc-
tion (see Figure 19).
strokes with file should sharpen cutter.
6. After each cutter if sharpened, move
chain forward to sharpen next cutter.
File all cutters on one side of chain.
7. Move to other side of chain and repeat
process.
OWNER'S MANUAL
Note: Do not clamp chain.
File at midpoint of guide bar.
Two or three
Note:
13
Filing
Direction
30° Guide
Mark
Note: This illustration shows file guide
placement and filing direction for
sharpening cutters on left side of chain.
Figure 19 - File and File Guide Placement
On Chain
Left Side
of Chain
Depth Gauge
(left side
of chain)
Top Plate
Groove
(left side
of chain)
Groove
Right Side
of Chain
Figure 20 - Chain Part Locations
File Guide
4 mm (5/32")
Round File
Top Plate
(right side
of chain)
Depth Gauge
(right side
of chain)
Continued