Filling Oil Tank - Remington EL-7 16 Manuel Du Propriétaire

ASSEMBLY
Continued
Tapping
Screw
Guide Bar
Bolts
Mounting
Stand-Outs
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Adjusting
Block
Figure 4 - Part Locations For Assembling Guide Bar
105020
For parts contact: www.PartsFor.com
Front Hand
Towards
Guard
Guide
Bar Nose
Cutting
Edge
Drive
Sprocket
Adjusting
Plate
Adjusting
Screw
Sprocket
Support
OWNER'S MANUAL

FILLING OIL TANK

Cutting
Edge
1.
2.
3. Replace oil cap at once. Tighten oil cap
Saw
Chain
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw
is not in use. Empty oil tank , tighten oil
cap, and store upside down after each use
to prevent seepage.
Guide
Bar
Adjusting
Hole
Guide Bar
Nuts
7
For more information, visit www.desatech.com
Remove oil cap.
Fill oil tank with SAE #30 motor oil.
Note: For temperatures below -1°C,
use SAE #10 oil. For temperatures
above 24°C, use SAE #40 oil.
firmly for good seal. This will avoid oil
seepage from tank.