Safety Warning - TEMPUR Premium Flex Instructions D'utilisation Et D'entretien

Instructions for Use and Care
6
TEMPUR ® Premium Flex
Thank You
... for choosing a TEMPUR ® Bed Base. This product
is made to stringent quality standards. Should you
have any complaint despite correct assembly and use,
contact your specialist dealer.

Safety warning

TEMPUR ® Bed Bases meet requirements and
specifications of DIN EN 1725. As specified the bed
base should be used as a foundation in conjunction
with a standard mattress. With normal use (lying,
sleeping, sitting) a maximum strain of 120 kg over the
entire bed surface is possible without any restriction.
Under certain conditions, it is possible to expose
the bed to a higher strain as long as its intended
purpose is taken into consideration. Please note that
the manufacturer cannot take any responsibility for
incorrect use and capacity overload.
Please note:
• When adjusting the position of the base, take
care that your fingers do not get caught in the
mechanism.
• Make sure that the base fits properly into your
bedstead. If not, fix legs (available as optional
extras) to the base.
To prevent distortion of fittings, the TEMPUR ® Bed
•
Base must be placed on an even floor.
• To prevent damage to parts, make sure that all the
fittings are properly slotted into place.
• Sitting on either the foot end or head end in the
raised position can cause strain and damage to
parts.
• Make sure to keep yourself and others clear of the
shearing points when adjusting the position of the
base. Do not allow children to adjust the position!
Otherwise there is a risk of crushing injury.
• Ensure that nothing hinders or obstructs the
adjusting mechanism or motors.
• Small articles can be swallowed by children,
which can lead to injuries as well as danger of life.
Therefore, these articles must be kept away of
children.
Mounting the TEMPUR ® Bed Base
• When placing the bed base in the bedstead, make
sure that it is firmly supported by at least four
fastening points.
• If you are going to use the bed base on its own,
without a bedstead, make sure that the legs are on
an even surface and securely mounted.
• In the case of an adjustable base, remove the cable
clips before use. Make absolutely sure that all the
clips have been removed before using the base for
the first time, as failure to do so could damage the
motors or the base itself.
• If the remote control is not used for lengthy periods,
remove the batteries to prevent damage from
leakage.
• We recommend the installation of optional support
legs on oversize bases from 120 cm width.
The TEMPUR ® Bed Base complies with DIN EN
•
1725 (Beds & Mattresses: Safety Standards & Test
Methods) as well as LGA (Bavarian Trade Institute)
standards.
Adjusting the position of the bed base
Manually adjustable models are adjusted by pulling
the loop upwards. To lower, pull the adjustable parts
up as far as they will go, then slowly lower them again.
For mechanically adjustable models, press the switch.
Take note of the safety instructions above when
adjusting the position of the base.
Individual firmness adjustment
The plates are preinstalled and settings may be
adjusted by a simple turning motion of the inner ring.