Important - Ryobi EJ500 Manuel D'utilisation

GB
FR DE ES
„ Make sure the blade is inside the area to be cut.
„ Start your saw by using high speed and slowly lower
the blade into the workpiece until the blade cuts
through the wood.
„ Continue lowering the blade into the workpiece until
the base rests flat on the work surface, then move the
saw forward to complete the cut.
„ Use only the 7 teeth per inch blade for this type of cut.
METAL CUTTING
Many kinds of metals can be cut with your saw.
Be careful not to twist or bend the blades. Do not force.
If the blade chatters or vibrates excessively, use a ¿ nertooth
blade or higher speed. If blade heats excessively, use lower
speed. If blade teeth become ¿ lled or clogged when cutting
soft metals, such as aluminum, use a coarser-tooth blade
or lower speed. We recommend the use of oil when cutting
metals to keep blades cool, increase cutting action, and
prolong blade life. Clamp the work ¿ rmly and cut close
to the clamping point to eliminate any vibration of the
workpiece being cut.
When cutting conduit, pipe or angle iron, clamp work in a
vise if possible and saw close to the vise. To cut thin sheet
materials smoothly, "sandwich" the material between
hardboard or plywood and clamp the layers to eliminate
vibration and material tearing. By doing this, the material
will be cut smoothly. Lay out your pattern or line of cut on
top of the "sandwich".

IMPORTANT!

When cutting metal, keep exposed portion of saw bar
clean and free of metal chips by wiping frequently with
an oily cloth. Use extreme caution in disposing of oily
cloth after completion of job to prevent potential ¿ re
hazard.
SAWDUST BLOWER DEVICE
See Figure 7.
„ With the air jet of the sawdust blower device, the
cutting line can be kept free of dust and chips.
„ Switching on the sawdust blower device: For cuts in
materials with high removal rate, such as in wood,
plastic, etc.. Push dust blower button up.
„ Switching off the sawdust blower device: For cuts
in metal and when a dust extraction system (not
included) is connected. Push dust blower button down.
TO CONNECT DUST EXTRACTION SYSTEM (NOT IN-
CLUDED)
„ Unplug the tool.
IT NL PT DK SE FI NO RU PL CZ
English
Failure to unplug your saw could result in accidental
starting causing possible serious injury.
„ Connect the nozzle of the dust collection system to
the dust port.
OPTIONAL EDGE GUIDE (NOT INCLUDED)
See Figure 8.
An edge guide is available for use with your saw and can
be used for making crosscuts and rip cuts.
TO INSTALL:
„ Unplug your saw.
Failure to unplug your saw could result in accidental
starting causing possible serious injury.
„ Insert arm of the edge guide through the two slots in
the base of your saw.
„ Adjust edge guide to the desired width and lock in
place with the edge guide screw.
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.
MAINTENANCE
GENERAL
All other parts represent an important part of the class
II insulation system and should be serviced only by a
quali¿ ed service technician.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents. Use clean cloths to remove
dirt, dust, oil, grease, etc.
3
HU RO LV LT EE
WARNING
WARNING
WARNING
HR SI SK GR TR