Reer 5006 SCOPI Manuel De L'utilisateur page 67

Operating Steps To Set The Transceivers To Baby And Parent Mode
In default setting both units are programmed as equal transceivers (PMR 446 walkie-
talkies). For use as baby monitor select one of the units as baby unit and the other one as
parent unit.
This is how it works:
Transmit
PTT button
Button
Parents can talk to their crying baby during a transmission break (transmission is interrupted
after 20 seconds and the talkback function is activated for 10 seconds).
Quick Start – Set Your
reer 5006 Scopi To Baby Monitor Mode
Repeat the setting for the second unit.
For the baby unit select between 9 baby channels
b1 to b9, for the parent unit P1 to P9.
Baby and parent unit must use the same channel
number, such as b1 and P1.
This is all you have to set for use as a normal
baby monitor!
The baby unit automatically monitors the baby for
sounds and communicates with the parent unit via
the automatic out-of-range control. In default setting
the highest sensitivity level is preset and the out-of-
control function is activated. The display shows
As long as this icon is displayed the units are
communicating.
• Turn both units on:
• On the first unit press the MENU button
twice. oF on the right and a baby icon
the bottom center on the display are flashing.
Press to select b (for baby unit) or P (=
parents).
• Briefly press the PTT button (left side) to
confirm or simply wait a few seconds.
• Press the MENU button once and select the
channel number.
3 seconds.
in
.