Programmation; Technical Support / Information - Fortin KEY-OVERRIDE-ALL Guide D'installation

KEY-OVERRIDE-ALL
Copyright © 2009-2011, FORTIN AUTO RADIO INC
PROGRAM. 1
1
Connector 1 (Black):
Determin the type of installation:
1.A
- INSTALLATION WITH DATA-LINK (See P.1, Plan 1)
- INSTALLATION WITHOUT DATA-LINK (See P.1, Plan 2)
Connector 2 (White):
1.B
Make the connections associated with the
vehicle in the VEHICLE FIT GUIDE (P.2-3)

PROGRAMMATION

Vehicle equipped with SMART KEY
10'
2
3
KEY#1
4
KEY#1
5

TECHNICAL SUPPORT / INFORMATION

Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
change without notice. Visit www.ifar.ca to get latest version.
ALL RIGHTS RESERVED
Make the connections to the vehicle:
Remove all keys from key remote cards.
Keep the card away from the vehicle (10
feet/3 meters minimum) to proceed with the
programming procedure.
Keep programming button pressed while
inserting connector 2.
Insert connector 1.
Release the programming button when the
LED turns ON.
Insert the first functional key into
the ignition barrel and turn the
ignition ON.
When the security light turns OFF,
turn the key to the OFF position and
remove the first key from the
barrel.
FORD / JAGUAR / MAZDA / LINCOLN / MERCURY
SEE VEHICLE FIT GUIDE (P.2) TO IDENTIFY THE SYMBOL.
For the vehicles identif
round symbol
(1 key required)
KEY#1
6
Insert the first functional
key into the ignition barrel
again and turn the ignition
ON.
KEY#1
7
When the
security light turns OFF,
turn the key to the OFF
position and remove the
first key from the barrel.
8.a
For MANUAL
Transmission:
Press and hold the programming
button untill the LED flashs once,
then release
8.b
With a jumper wire, apply
power (12v) to the vehicles
ignition wire until the dash
board security light turns
OFF. Remove the jumper.
9
Technical support:
TEL: 514-255-HELP (4357)
1-877-336-7797
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - Rev. ZM - 03 / 11 / 2011
W e b s i t e : h t t p : / / w w w . i f a r . c a
For the vehicles identified with
ied with
square symbol
(2 key required)
The following procedure
must be completed in 3
to 5 seconds :
6
Insert the second functional
key into the ignition barrel and
turn the ignition ON.
7
dash board
W h e n
security light turns OFF, turn
the key to the OFF position
and remove the second key
from the barrel.
The following procedure must be
completed in 3 to 5 seconds :
For AUTOMATIC
Ignition
Activate the remote starter.
12V
If the LED flashes 10 times, the
module is programmed.
If the LED turns ON, repeat from step 1.
KEY # 2
KEY # 2
t h e d a s h b o a r d
Transmission:
P.11