Installation; Fitting The Feet; Wall Mounting - SilverCrest SKD 2300 B2 Mode D'emploi

Installation

CAUTION
► During assembly, lay the appliance on a soft surface, e.g. on a carpet, to
avoid any damage.

Fitting the feet

♦ Place the appliance on a soft surface with the base uppermost.
♦ Fit the feet

Wall mounting

WARNING
► When drilling the holes ensure that any electric cables or other installations
in the wall, such as water pipes, are not damaged.
► The supplied wall plugs
stone. Before starting the installation, please check your installation location
carefully for its suitability for the anchors. If in doubt, consult a professional.
NOTE
► When selecting the mounting location make sure that a suitable mains wall
socket is located within the plug-in radius of the mains power cord.
► The feet
♦ Mark two drill holes at a minimum height of 487 mm and at a distance of
566 mm (see Fig. drill diagram).
♦ Using a drill and an 8 mm drill bit, drill two holes with a minimum depth of
40 mm.
Fig. drill diagram
♦ Insert the supplied wall plugs
♦ Screw the two wall brackets
│ GB │ IE
■ 12
6
to the bottom of the appliance using 2 screws
are only suitable for mounting in concrete or
37
6 may not be screwed on if the appliance is wall-mounted.
min. 487 mm
566 mm
into the holes.
37
to the wall using the supplied screws
34
on each foot.
35
ø 8 mm, 40 mm
.
36
SKD 2300 B2