Unpacking; Machine Description; Micromax™ 17B-20B/20Dc-20Dd Automatic Scrubber Operation - Nilfisk Advance Micromax 17B Instructions D'utilisation

WARNING!
– Carefully read all maintenance/repair instructions before
carrying out any maintenance/repair procedure.
– Before using the battery charger, ensure that frequency
and voltage values, indicated in the machine serial
number plate, match the mains values.
– Take all necessary precautions to prevent hair, jewelry
and loose clothing from being caught by the machine
moving and vacuuming parts.
– Do not smoke during battery charging.
– Do not leave the machine unattended without being sure
that the machine cannot move independently.
– Do not use the machine on surfaces with a gradient
greater than the one indicated on the machine.
– Do not wash the machine with pressurized water, or with
corrosive substances.
– Do not use the machine in particularly dusty areas.
– While using this machine, take care not to cause
damage to people.
– The storage temperature must be between +32°F and
+104°F (0°C and +40°C).
– The machine working temperature must be between
+32°F and +104°F (0°C and +40°C).
– The humidity range should be between 30% and 95%.
– Always protect the machine against the sun, rain and
bad weather, both during operation and inactivity
condition.
– Do not use the machine as a transport vehicle.
– Do not allow the brush to operate while the machine is
stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher. Do not use
water.
– Do not bump into shelves or scaffoldings, particularly
where there is a risk of falling objects.
– Do not tamper with the machine safety guards; follow the
ordinary maintenance instructions scrupulously.
– Do not remove or modify the plates affixed on the
machine.
– In case of machine malfunctions ensure that these are
not caused by a lack of maintenance. Otherwise,
request assistance from the authorized personnel or the
Service Center.
– If parts must be replaced, order ORIGINAL spare parts
from a Dealer or authorized Retailer.
– To ensure the machine proper operation and safety
conditions, the authorized personnel or the Service
Center must carry out the Scheduled Maintenance
detailed in the related chapter of this Manual.
– The machine must be disposed of properly, because of
the presence of toxic-harmful materials (battery acid, oil,
etc.), which are subject to standards that require
disposal in special centers (see the Scrapping chapter).
– If the machine is used according to the instructions, the
vibrations do not cause dangerous situations. The
machine vibration level is under 2.5 m/s
Micromax™ 17B–20B / 20DC–20DD — 909 5426 000(2)2005-03
– Do not leave any object penetrate in the openings. Do
not use the machine in case the openings are clogged;
always keep the openings free from dust, hair and any
other foreign material which could reduce the air flow.
– This machine cannot be used on roads or public streets.
– Pay attention to the machine transfers when
temperature is under freezing point. The water in the
recovery tank or in the pipes could freeze and damage
the machine.
– Use the brushes and the pads supplied with the machine
and those specified in the Instructions for Use. Using
other brushes or pads could reduce safety.

UNPACKING

To unpack the machine carefully follow the instructions on the
packing.
On delivery, check that the machine and its packing were not
damaged during transportation. If the damages are evident,
keep the packing and have it checked by the Parcel Service
that delivered it. Call the Parcel Service immediately to fill in
a request for a compensation for damages.
Please check that the following items have been supplied with
the machine:
1. Technical documents:
– Instructions for Use
– Electronic Battery Charger Manual
– Spare Parts List
2. No. 1 lamellar fuse

MACHINE DESCRIPTION

MICROMAX™ 17B–20B/20DC–20DD
AUTOMATIC SCRUBBER OPERATION
The scrubber-dryer is used to clean (scrubbing and drying)
smooth and solid floors, in civil or industrial environment,
under safe operation conditions and by a qualified Operator.
The automatic scrubber cannot be used for fitted carpet and
carpet cleaning.
AGREEMENTS
Forward, backward, front, rear, left or right are intended with
reference to the Operator's position with the hands on the
handlebar (2, Fig. C).
Control panel and commands
(See Fig. B)
1. Control panel and commands
2. Charged battery warning light (green)
3. Semi-discharged battery warning light (yellow)
4. Discharged battery warning light (red)
5. Brush/pad-holder/cylindrical brushes (*) switch
6. Suction switch
7. Solution flow control lever
8. Control panel and commands mounting screws
9. Ignition key (*)
10. Drive control levers (*)
11. Drive speed governor (*)
2
.
(*) "20DD–20DC" versions only
INSTRUCTIONS FOR USE
3