Replacing One Type Of Exhaust Filter With Another; When To Change The Thread Lifters; How To Replace The Thread Lifters - Miele S 6210 Mode D'emploi

en
Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters
(dia. 29):
a Air Clean
b Active Air Clean SF-AAC 50 (black)
c Active HEPA SF-AH 50 (blue)
Please note:
1. If you wish to replace the Air Clean
filter a with an Active Air Clean filter b
or an Active HEPA filter c, it is essential
that you remove the filter grille before
fitting the new type of filter.
2. If you wish to replace the Active Air
Clean filter b or the Active HEPA filter c
with an Air Clean filter a, then it is
essential that you also fit the filter grille *,
see dia. 31.
* Filter grille – see "Optional
accessories".
Do not use more than one exhaust
filter at a time.

When to change the thread lifters

The thread lifters on the suction inlet of
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.
40
How to replace the thread lifters (dia.
34 + 35)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Upholstery nozzle SPD 10
(depending on model) (dia. 36)
a Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
b Fit a new thread lifter unit and lock
into position.
Cleaning the roller on the floorhead
(dia. 37)
(not necessary for FiberTeQ and AirTeQ
floorheads)
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove it.
c Take out the roller.
^ Remove any threads and hair,
replace the roller and refit the
bearing.
Replacement parts are available from
your Miele retailer or from Miele (see
back cover for contact details).