Henny Penny 100 Serie Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. Put on protective gear: Use all McDonald's approved safety equipment including, Apron, Face Shield and
Gloves. Hot oil can cause severe burns.
2. Press and hold
3. Press and release
"PUT ON *PPE*, followed by CONFIRM? and YES NO.
4. Press √ √ √ √ √ and display shows DRAINING and the oil drains from the vat, or press X button for NO and
controls return to normal operation.
5. If filtering is desired, press √ √ √ √ √ button for YES and display shows DRAINING
and the oil drains from the vat. Gas units, continue to step 7.
6. Electric units only. Use the lift tool and lift the hinged element to clean the
bottom of the vat. Use care not to damage high limit bulb. Figure 1.
7. Use the scouring tool, a nylon scouring pad, and a small amount of McD Fryer
Cleanser to scrub the inside of the vat. Be careful not to damage the
sensing probes.
8. Once the vat is clean and the display shows SCRUB COMPLETE?, and YES NO. Press √ √ √ √ √ and the display
shows WASH VAT?, and YES NO.
9. Lower the elements (electric units only) and press √ √ √ √ √ and display shows WASHING. Once the wash cycle
is complete, display shows WASH AGAIN?, and YES NO.
10. Press √ √ √ √ √ if another wash is needed, otherwise press X button for NO and the display shows RINSING.
When rinsing is complete, display shows RINSE AGAIN?, and YES NO.
11. Press √ √ √ √ √ if another rinse is needed, otherwise press X button for NO. Display shows POLISH, and YES.
12. Press √ √ √ √ √ button and the oil is "polished" and the display shows 5:00, followed by STOP POLISH. If desired,
press X button for STOP to stop the polishing, otherwise the oil is polished for 5 minutes.
13. The display shows FILL VAT?, and YES NO. Press √ √ √ √ √ and display shows FILLING and vat fills with oil.
14. Once full, display shows IS POT FILLED?, and YES NO. Press √ √ √ √ √ and fryer returns to normal operation.
The filter pad or paper must be replaced daily!
Any problems, refer to manual or contact Henny Penny Corp. 1-800-417-8405, or 937-456-8405.
These instructions are meant to be guidelines, not complete operating instructions. Read and
understand the complete operater's manual supplied with each unit.
3-14-08
MAINTENANCE FILTER
(End of Day Manual Filter)
(on either side) until display shows 1.AUTO FILTER?.
and display shows 2.MAINT FILTER?. Press √ √ √ √ √ button and display shows
Figure 1
FM07-283-A

Publicité

Table des Matières
loading

Table des Matières