Honda Power Products HSS622 Manuel De L'utilisateur page 55

Track-adjustment (track type only)
ADJUSTMENT INTERVAL: Every year, before operation
Make sure the tracks are clean and dry before adjustment. The tracks
cannot be correctly adjusted if clogged with snow or debris, or coated
with ice.
With the snowblower resting on
its tracks, check track deflection
by pressing down midway
between the wheels with a force
of 15 kgf (33 lbf).
When correctly adjusted, track
deflection should be:
25.0–30.0 mm (0.98–1.18 in)
Adjusting procedure:
1.Loosen the left and right tension bolt lock nuts at the rear axle, and
turn the adjusting nuts to correctly tension both tracks.
2.After adjustment, tighten the lock nuts securely.
Tires (wheel type only)
CAUTION:
• Do not operate with a flat tire. This may cause the bead to come off.
• Over inflation can cause premature tire failure. Inflate the tires to
manufacturer's recommended tire pressure.
Before each use, check the tire
pressure with an air pressure
gauge.
Pressure:
80~100 kPa (0.8~1.0 kgf/cm
52
Decrease tension
Increase tension
2
, 11.4~14 psi)
25.0–30.0 mm
(0.98–1.18 in)
ADJUSTING NUT
TENSION BOLT
LOCK NUT
TRACK