Honda Power Products HSS622 Manuel De L'utilisateur page 39

7. SNOWBLOWER OPERATION
Skid plate, scraper
Adjust the skid plate and scraper positions.
Before adjusting the skid plate and scraper positions, be sure to stop
the engine and remove the spark plug cap from the spark plug.
The skid plate and scraper have three adjusting positions. Select the
position according to the surface conditions described in the chart.
NOTE: Adjust the height equally on both sides.
After adjusting the height, be sure to tighten the adjusting bolts and
nuts securely.
HEIGHT ADJUSTING BOLT
(Track type only)
Operation
Regular work
Clearing of hard,
compact snow
Clearing of snow
covering uneven
ground
36
HEIGHT,
ADJUSTING BOLT
(Track type only)
MIDDLE
UPPER
LOWER
SCRAPER
Scraper Skid
Middle Middle
position position
Upper Upper
position position
Upper Lower
position position
TO RAISE
TO LOWER
SKID PLATE
5 mm
2–7 mm
25–30 mm