Safety-Alert Symbol; Important Safety Instructions - Toro Flex-Force Power System 60V MAX Manuel De L'utilisateur

Safety-Alert Symbol

The safety-alert symbol
manual and on the machine identifies important safety
messages that you must follow to prevent accidents.
Safety-alert symbol
The safety-alert symbol appears above information
that alerts you to unsafe actions or situations and
is followed by the word DANGER, WARNING, or
CAUTION.
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious
injury.
WARNING indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
This manual uses two other words to highlight
information. Important calls attention to special
mechanical information and Note emphasizes general
information worthy of special attention.
(Figure 2) shown in this
Figure 2
Safety
IMPORTANT SAFETY
INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS—This manual
contains important safety and operating
g000502 instructions for Toro 60V lithium-ion battery
packs and Toro 60V lithium-ion battery chargers.
2. Before using the battery charger, read all the
instructions and cautionary markings on the
battery charger, battery pack, and product using
the battery pack.
3. CAUTION—To reduce risk of injury, charge Toro
60V lithium-ion battery packs with Toro 60V
lithium-ion battery chargers only. Other brands
of battery packs may burst, causing personal
injury and damage.
4. WARNING—Plugging the battery charger into
an outlet that is not 120 V can cause a fire or
electric shock. Do not plug the battery charger
into an outlet other than 120 V. For a different
style of connection, use an attachment plug
adapter of the proper configuration for the power
outlet if needed.
5. These devices comply with Part 15 of the FCC
rules. Operation is subject to the following
2 conditions: (1) These devices may not
cause harmful interference; and (2) these
devices must accept any interference received,
including interference that may cause undesired
operation.
3