Spare Parts; Warranty - Abicor Binzel ABICOOLER 1300 115 CSA Mode D'emploi

ABICOOLER 1300 115V CSA

13.3 Spare parts

Tab. 4
Item description
Tank, milky white
Tank cap, srew thread
Coupling DN5-G1/4 I
Coupling DN5-G1/8 A
M5 × 12 screw, self-tapping
Rocker switch 250 V, illuminated
Fuse holder
Connection nipple G1/4
Fine wire fuse T4A 5 × 20 mm
Rubber foot D = 25 × 24 black
Handle 179 black
Heat exchanger
Motor/pump 230 V incl. fan
Autotransformer
Rubber puffer A 20 × 15 – M6 × 16
Test plug 2-pole
Tool for device bleeding
Power cable 3G 2.5 mm
Test socket 2-pole
Cable, 3-pole DFM
Discharge hose
Plug-in nozzle DN5–9
Flow control
Hose set 2 m with 10 clamps

14 Warranty

This product is an original ABICOR BINZEL product. Alexander Binzel Schweisstechnik GmbH & Co. KG
guarantees correct manufacture and assumes a factory production and function warranty for this product
upon delivery, which is in line with the most current technology and the regulations in force.
If ABICOR BINZEL is responsible for a defect that is present, ABICOR BINZEL is obliged to remedy the
defect or deliver a replacement at its own cost and its own discretion. The warranty covers manufacturing
faults, but not damage resulting from natural wear and tear, overloading or improper use. The warranty
period is defined in the General Terms and Conditions. Exceptions in the case of specific products are
regulated separately. Warranty will also be rendered invalid if spare parts and wear parts are used that are
not original ABICOR BINZEL parts and if the product has been repaired improperly by the user or a third
party. Wear parts are excluded in general from the warranty. In addition, ABICOR BINZEL is not liable
for damage caused by using our products. Questions about warranty and service can be addressed to the
manufacturer or our distributors. For more information, visit www.binzel-abicor.com.
Spare parts
2
USA/4 m
14 Warranty
EN - 24