DeWalt XR LI-ION DCS350 Notice D'instructions page 41

CAUTION: If the cutting die cap screws
or hex wrench are lost or damaged
replace with identical replacement parts.
Recommended replacement parts for
use with your tool are available at extra
cost from your local dealer or authorized
service centre. Always use identical
replacement parts.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
WARNING: Cut Hazard. NEVER
have any part of your body near the
cutters. Serious personal injury may
occur.
WARNING: Cut Hazard. To reduce
the risk of serious personal injury,
DO NOT use the threaded rod cutter
with any kind of accessory or attachment
other than those recommended by
D WALT.
e
WARNING: Cut Hazard. Wear gloves
when handling threaded rod. The ends
and threads can be sharp and can cause
serious personal injury.
Proper Hand Position (Fig. 6)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the
main handle, with the other hand securing the work
piece.
Trigger Switch (Fig. 4)
WARNING: This tool has no provision to
lock the trigger switch in the ON position
and should never be locked ON by any
other means.
To turn the tool ON, squeeze the trigger switch (A).
To turn the tool OFF release the trigger.
Reset/Lock-Off Button (Fig. 4)
The spring-loaded reset/lock-off button (B)
determines the direction of the tool and also serves
as a lock-off button.
To select normal cutting operation, release the
trigger switch and depress the reset/lock-off button
on the right side of the tool.
The center position of the button locks the tool in
the off position. When changing the position of the
reset/lock-off button, be sure the trigger is released.
To select reset, depress and hold the reset/lock-off
button on the left side of the tool.
NOTICE: The rod cutter could stall during a cut
either as a result of a depleted battery, or as a result
of cutting a material too hard or too large.
Should the unit stop during the cut for any reason,
press and hold the spring-loaded reset/lock-off
button (B) in reset position (left side) and pull the
trigger switch (A) to open the cutter jaws and
remove the material.
NOTICE: Do not attempt to cut in the reset direction.
Damage to the tool could result.
LED Worklight (Fig. 5)
CAUTION: Do not stare into
worklight. Serious eye injury could
result.
There is a worklight (I) located above the cutting
area of the tool. The worklight is activated when
the trigger switch is depressed. If the trigger switch
remains depressed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate
work surface and is not intended to be used as a
flashlight.
english
Cutting
Lock-off
Reset/Return
39