Télécharger Imprimer la page

AL-KO MULTITOOL MT 40 Mode D'emploi page 20

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
GB
7 MAINTENANCE AND CARE
WARNING! Danger of cuts and lacera-
tions. Danger of cuts and lacerations when
reaching into sharp-edged, moving appliance
parts and into cutting tools.
Before maintenance, care and cleaning work,
always switch off the appliance. Remove the
rechargeable battery.
Always wear protective gloves during mainte-
nance, care and cleaning work.
Do not get the machine wet or expose it to
moisture.
Clean plastic parts with a cloth and do not
use any cleaning agents or solvents.
Check the electrical contacts for corrosion,
clean with a fine wire brush if necessary and
then spray with a contact spray.
Check the cutting blade for damage and – if
damaged – have replaced.
Clean the cutting blade and spray with rust-
proofing oil.
8 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
Always wear protective gloves during mainte-
nance, care and cleaning work!
Malfunction
Cause
Cutting
No oil on the
blade be-
cutting
comes hot
blade.
when run-
ning. Gener-
ation of
smoke.
Cutting
blade is
blunt.
Nicks in
the cut-
ting
blade.
20
Remedy
1. Switch off the
appliance
and remove
the recharge-
able battery.
2. Clean and oil
the cutting
blade.
3. Insert the re-
chargeable
battery
again.
Contact an AL-
KO service cen-
tre.
Malfunction
Cause
Branches
Cutting
are not
blade is
cleanly cut.
blunt.
Branches
The sliding
are often
play of the
jammed in
cutting blade
the cutting
is too great.
blade.
Motor run-
Appliance
ning, but the
faults
cutting blade
does not
move.
Appliance vi-
Appliance
brates un-
faults
usually.
Other faults
See "Multitool MT 40 – basic ap-
pliance" operating instructions.
NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
9 TRANSPORT
Before transporting, carry out the following mea-
sures:
1. Switch off the tool.
2. Remove the rechargeable battery from the
basic appliance.
3. Separate the basic appliance, extension pipe
(if present) and attachment from each other.
NOTE The nominal energy of the re-
chargeable battery is more than 100 Wh. There-
fore, observe the following transport instructions.
The li-ion rechargeable battery contained in the
appliance is subject to the hazardous goods law,
but can be transported under simplified condi-
tions:
The rechargeable battery can be transported
on public roads by the private user without
further conditions provided it is packaged for
retail sale and the transport serves personal
purposes.
Commercial users who carry out the trans-
port in connection with their main activity
(e.g. delivery from and to building sites, or
demonstrations) can also take advantage of
this simplification.
Maintenance and care
Remedy
Contact an AL-
KO service cen-
tre.
Contact an AL-
KO service cen-
tre.
Contact an AL-
KO service cen-
tre.
Contact an AL-
KO service cen-
tre.
HTA 4045

Publicité

loading

Ce manuel est également adapté pour:

Hta 4045