Makita ER2650LH Instructions D'emploi D'origine page 4

– Start the Petrol String Trimmer only in accordance with the instructions.
– Do not use any other methods for starting the engine!
– Use the Petrol String Trimmer and the tools only for such applications as
specified.
– Only start the engine, after the entire assembly is done. Operation of the
device is only permitted after all the appropriate accessories are attached!
– Before starting make sure that the cutting attachment has no contact with
hard objects such as branches, stones etc. as the cutting attachment will
revolve when starting.
– The engine is to be switched off immediately in case of any engine problems.
– Should the cutting attachment hit stones or other hard objects, immediately
switch off the engine and inspect the cutting attachment.
– Inspect the cutting attachment at short regular intervals for damage (detection
of hairline cracks by means of tapping-noise test).
– During operation always hold the Petrol String Trimmer with both hands.
Never hold the Petrol String Trimmer with one hand during use.
Always ensure a safe footing.
– Operate the equipment in such a manner as to avoid inhalation of the exhaust
gases. Never run the engine in enclosed rooms (risk of gas poisoning).
Carbon monoxide is an odorless gas.
– Switch off the engine when resting and when leaving the equipment
unattended, and place it in a safe location to prevent danger to others or
damage to the machine.
– Never put the hot Petrol String Trimmer onto dry grass or onto any
combustible materials.
– The cutting attachment has to be equipped with it appropriate guard.
Never run the cutter without this guard!
– All protective installations and guards supplied with the machine must be
used during operation.
– Never operate the engine with faulty exhaust muffler.
– Shut off the engine during transport.
– During transport over long distances the tool protection included with the
equipment must always be used.
– Ensure safe position of the equipment during car transportation to avoid fuel
leakage.
– When transporting, ensure that the fuel tank is completely empty.
– When unloading the equipment from the truck, never drop the Engine to the
ground or this may severely damage the fuel tank.
– Except in case of emergency, never drop or cast the equipment to the ground
or this may severely damage the equipment.
– Remember to lift the entire equipment from the ground when moving the
equipment. Dragging the fuel tank is highly dangerous and will cause damage
and leakage of fuel, possibly causing fire.
Refueling
– Shut off the engine during refueling, keep away from open flames and do not
smoke.
– Avoid skin contact with mineral oil products. Do not inhale fuel vapor. Always
wear protective gloves during refueling. Change and clean protective clothing
at regular intervals.
– Take care not to spill either fuel or oil in order to prevent soil contamination
(environmental protection). Clean the Petrol String Trimmer immediately after
fuel has been spilt.
– Avoid any fuel contact with your clothing. Change your clothing instantly if
fuel has been spilt on it (to prevent clothing catching fire).
– Inspect the fuel cap at regular intervals making sure that it can be securely
fastened and does not leak.
– Carefully tighten the fuel tank cap. Change location to start the engine (at
least 3 meters away from the place of refueling).
– Never refuel in closed rooms. Fuel vapors accumulate at ground lever (risk of
explosions).
– Only transport and store fuel in approved containers. Make sure the fuel
stored is not accessible to children.
• Resting
• Transport
• Refueling
• Maintenance
• Tool replacement
4
3 meters