Subwoofer - JVC KD-R821BT Manuel D'instructions

Masquer les pouces Voir aussi pour KD-R821BT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Menu item
LCD Type
Contrast
PRO EQ
Fad/Bal *
Loud
Volume
Adjust

Subwoofer

On/Off
Subwoofer
LPF *
7
Subwoofer
Level *
7
Subwoofer
Phase *
7
HPF
Beep
Amplifier
Gain *
8
*
4
Depends on the <Dimmer Set> setting.
*
5
If you are using a two-speaker system, set the fader level to <00>.
*
6
This adjustment will not affect the subwoofer output.
*
7
Displayed only when <On> is selected for <Subwoofer On/Off>.
*
8
The volume level automatically changes to "Vol 30" if you change to <Low Power> with the volume level set
higher than "Vol 30."
24
ENGLISH
Negative : Negative pattern of the display. / Positive : Positive pattern of the display. /
Auto : Positive pattern will be selected during the day time *
be used during the night time *
Level 01 — Level 08 [ Level 05 ] : Adjust the display contrast to make the display
indications clear and legible.
For settings, see page 22.
Fad (fader) : F6 — R6 [ 0 ] : Press 5 / ∞ to adjust the front and rear speakers output
5,
*
6
balance. / Bal (balance) : L6 — R6 [ 0 ] : Press 4
and right speakers output balance.
On : Boost low and high frequencies to produce a well-balanced sound at a low volume
level. / Off : Cancels.
Level –5 — Level +5 [ Level 0 ] : Presets the volume adjustment level of each source
(except "FM"), compared to the FM volume level. The volume level will automatically
increase or decrease when you change the source. Before adjustment, select the source you
want to adjust. ("FIX" appears on the display if "FM" is selected as the source.)
On : Turns on the subwoofer output. / Off : Cancels.
LOW 55Hz / MID 85Hz / HIGH 120Hz : Frequencies lower than 55 Hz/ 85 Hz/
120 Hz are sent to the subwoofer. / Off : Deactivates (all signals are sent to the rear
speakers).
Level 00 — Level 08 [ Level 04 ] : Adjusts the subwoofer output level.
0 Deg (normal) — 180 Deg (reverse) : Selects the subwoofer phase.
LOW 62Hz / MID 95Hz / HIGH 135Hz : Activates the High Pass Filter.
Frequencies lower than 62 Hz/ 95 Hz/ 135 Hz are cut off from the front/rear speakers. /
Off : Deactivates (all signals are sent to the front/rear speakers).
On / Off : Activates or deactivates the keypress tone.
Low Power : Vol 0 – Vol 30 (Selects if the maximum power of each speaker is less
than 50 W to prevent damaging the speakers.) / High Power : Vol 0 – Vol 50 /
Off : Deactivates the built-in amplifier.
Selectable setting, [ Initial: Underlined ]
4
.
4
; while negative pattern will
/ ¢
to adjust the left

Publicité

Chapitres

Table des Matières
loading

Table des Matières