Assembly Inumbra Into Arthur - Extremis INUMBRA Manuel D'instructions

ASSEMBLY INUMBRA INTO ARTHUR

WHAT YOU NEED
1 persoon
screwdriver
2. You can now insert the stainless steel tube in the
central aluminium plinth. The conical part of the
stainless steel tube must be facing upwards.
For ventilation purposes, the cover is not 100% water proof.
Do not leave closed if not completely dry. Do not leave the parasol closed for a long time if it is still damp or wet.
Store the parasol when not in use for a long time as follows: vertically, completely dry and in a dry environment.
1. Remove the large round tabletop of the Arthur table.
3. Screw the small disk to the central aluminium colon.
4. Put the parasol on the stainless steel tube as explained
WARNING
If you hear the cables whistling due to heavy wind or if you are not using
the parasol,
close it and use the slip-over cover to avoid the parasol from opening or
getting dirty.
Do not leave the parasol unattended when opened.
Ask for assistance when closing the parasol in strond winds. Opposite the
wind's direction, at least one person needs to guide the parasol's spines
downwards in order to avoid the parasol from blowing open fiercely
halfway down.
Unscrew the small round disk attached to the central
aluminium colon. Keep the disk and the screws close at
hand.
Then put the large round tabletop back onto the
assembly.
in point 6 - 7 - 8 on page 7.
english 9