Assembly Concrete Base - Extremis INUMBRA Manuel D'instructions

ASSEMBLY INUMBRA ON CONCRETE BASE
WHAT YOU NEED
1 person
no. 17 spanner
screwdriver
+/- 30 min.
2. Fix the plastic glides to the bottom of the concrete
tiles: put the supplied plugs into the holes and tighten
the glides with the supplied screws.
4. Position the stainless steel tube on top of the concrete
tiles. Make sure that the holes in the stainless steel
disk are perfectly aligned with the holes in the
concrete tiles. Position the flat section of the conical
part of the stainless steel tube where you wish your
handle to be. You can now attach the stainless steel
tube to the concrete tiles using the four supplied bolts.
Tighten them with a 17 mm openend wrench.
6 assembly inumbra on concrete (wheel) base
1. Position the first element of the cross-shaped base on
the floor where you wish to place the parasol. Then
slide the second element over first one ensuring that
the grooves correspond and fit perfectly.
3. Put the four concrete tiles on top of the cross-shaped
base. Align the holes in the concrete tiles with the
holes in the metal plate of the cross-shaped base. The
side with the bevelled corners should be facing
downwards.
5. You can now put the parasol on the stainless steel tube.
Make sure that the adjusting screw in the parasol pole
coincides with the flat section of the conical part of the
stainless steel tube. If this is not the case, you will not
be able to fully slide the parasol pole over the conical
part. When the conical part is completely hidden by
the parasol pole, it should be impossible to turn the
parasol. If this is however still possible, carefully
rotate the parasol until its pole completely covers the
conical part