Reversing The Door Swing; Tools Required; Before You Start - GE 16 Série Manuel D'utilisation Et D'installation

2

REVERSING THE DOOR SWING

IMPORTANT NOTES
When reversing the door swing:
them in the wrong places.
the doors.
IMPORTANT: Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.

TOOLS REQUIRED

Phillips screwdriver
5/16" hex-head
socket driver
Putty knife or thin-
blade screwdriver

BEFORE YOU START

1
1.1 Unplug the refrigerator from its electrical outlet.
1.2 Empty all door shelves, including the dairy
compartment.
CAUTION:
do so could damage the door stop.
Installation Instructions
Masking tape
T20 or T25 Torxdriver
(needed for some
models)
5/16" open-end
wrench
REMOVE THE FREEZER DOOR
2
2.1 Tape the door shut with masking tape.
2.2 With a 5/16" hex-head socket driver, remove the
screws that hold the top hinge to the cabinet.
2.3 Lift the hinge straight up to free the hinge pin
from the socket in the top of the door and set it
aside, along with its screws.
Top Hinge
2.4 Remove the tape and tilt the door away from the
2.5 Set the door on a non-scratching surface with the
outside up.
2.6 Transfer the 2 screws from the opposite side of
the cabinet to the screw holes vacated by the top
hinge removal.
11