Vortice VORT HRW 30 MONO EVO Livret D'instructions page 39

ENGLISH
To set the device as "RS485 network slave":
• Press simultaneously the Speed - Mode - Function buttons.
• Press in sequence the following buttons: MODE - MODE - SPEED - SPEED - FUNCTION - FUNCTION.
• Press the SPEED button within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as Slave.
• If the SPEED button is not pressed within 20 sec, the device will return to normal operation without making any changes
to the settings.
To set the device as "Even Unit":
• Press simultaneously the buttons: SPEED - MODE - FUNCTION
• Press in sequence the buttons: SPEED - SPEED - FUNCTION - FUNCTION - MODE - MODE.
• Press the SPEED button within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as an even numbered unit.
• If the SPEED button is not pressed within 20 sec, the device will return to normal operation without making any changes
to the settings.
To set the device as an "Odd Unit":
• Press simultaneously the SPEED - MODE - FUNCTION buttons.
• Press in sequence the buttons SPEED - SPEED - FUNCTION - FUNCTION - MODE - MODE.
• Press the FUNCTION key within 20 sec.
• All speed LEDs from 1 to 5 will blink briefly to indicate that the device has been set as an odd-numbered unit.
• If the FUNCTION button is not pressed within 20 sec, the device will return to normal operation without making any
changes to the settings.
Remote I/O
The connected device can be remotely controlled via clean contacts on remote input 1. If the remote input is active, the
keyboard on the machine is disabled.
• Remote input # 1:
- With input contact 1 closed, all the connected fans work in extraction at maximum speed.
- If 20 seconds since the last key press have not elapsed:
• The white EXTRACTION LED lights up.
• The white 1,2,3,4,5 LEDs light up.
39