Kohler K-3082 Guide D'installation page 7

Feed wires
through back
of cabinet
20A GFI
BREAKER
CIRCUIT
BREAKER
PANEL
B
G
W
Wiring Diagram
5. Position the Cabinets, Connect the Electricity
- Make sure all connections have been made if mounting multiple cabinets together.
NOTE: No more than three cabinets should be mounted together at the time of installation.
- Be sure the electrical wire is in position and can be reached from the front of the cabinets so electrical connections
can be made.
- Remove the attaching screw on the bottom of the electrical shelf and set shelf and screw aside.
- Set the bottom channel of the cabinet into the Z" mounting bar.
CAUTION: Risk of personal injury and product damage. Mirror cabinets are very heavy. It is recommended
that cabinets be lifted with assistance.
- While holding cabinet in place, feed the electrical wire through hole in the back of the cabinet, making sure you
have enough wire exposed to make the connection.
- Position top clips and drill holes through wall. If bracing is not being used, align top clips with stud(s). Fasten
clips securely using #10 x 2" screws.
NOTE: If the cabinet is not being fastened to a brace or stud you must attach it with the anchors supplied.
- Make electrical connections and replace the electrical cover.
Kohler Co.
Electrical Shelf
Screw
G
W
B
TB
G
B
W
Top Clip
Back of
Cabinet
#10 x 2" Screw
Bottom of Cabinet
7
Top of Cabinet
Channel
"Z" Mounting Bar
Back of Cabinet
1010988-2-
A