Kohler K-3082 Guide D'installation page 6

"Z" Mounting Bar
#10 x 2" Screw
4. Installing the "Z" Mounting Bar(s) and Top Clips
- Each cabinet is shipped with an aluminum Z" mounting bar which will be mounted to the wall to support the
weight of the cabinet. The bar should be installed in the center of the bottom header.
- Use a pencil to mark the wall where the bottom of the cabinet will be located. Using a level, draw a horizontal line
the length of the mounting bar. If installing multiple cabinets side by side, use a level to draw horizontal lines for
each Z" mounting bar.
- Drill a minimum of three evenly spaced 7/32" holes into the Z" mounting bar through the indentations (holes
should correlate to a stud behind the wall if no header was installed).
- Place the bottom edge of the Z" mounting bar against the horizontal line. Use the #10 x 2" pan head thread cut
screws to secure the Z" mounting bar to the wall.
NOTE: Use the plastic anchors supplied if no header was placed in the wall. Make sure each Z" mounting bar
has a minimum of three anchors per cabinet.
- Locate the three top clips for the cabinet and slide the clips into the groove located in channel on the top side of
the cabinet. Do not lift cabinet to wall until instructed.
A
1010988-2-
Do not lift cabinet to wall until instructed
6
Top Clip
Groove in
Channel
Kohler Co.