Pflege Und Wartung - DOMENA Xelys 1 Guide De Démarrage Rapide

Masquer les pouces Voir aussi pour Xelys 1:
Table des Matières

Publicité

PFLEGE UND WARTUNG

Die Bügeleisensohle kann durch Waschmittelrückstände, durch die Appretur der
Stoffe und Fasern verunreinigt werden und gleitet dann nicht mehr leicht über den
Stoff. Deshalb Bügeleisen nach dem Bügeln mit einem nichtflusenden Lappen
abreiben. Schwer zu entfernende Flecken und Ablagerungen sollten mit einem
Bügeleisen-Reinigerstift behandelt werden.
Auf keinen Fall alkalihaltige Produkte (z.B. Backofenreiniger), scharfe Reinigungs-
mittel, Scheuermittel oder Stahlwolle verwenden.
Das Bügeleisen gleitet nur dann leicht über den Stoff, wenn die Sohle
nicht verschmutzt ist.
WAS TUN WENN...
PROBLEM
URSACHEN
Kontrolllampe leuchtet nicht auf. - Stecker steckt nicht fest in der Steckdose
- Andere Ursachen
Das Bügeleisen wird nicht heiß - Thermostat steht auf mini
- Andere Ursachen
Es wird kein Dampf erzeugt
- Kein Wasser im Behälter
- Der Wasserbehälter ist nicht richtig eingesetzt
- Keine Filterpatrone im Behälter
- Die Kontrolllampe
- Andere Ursachen
Es kommt Dampf und Wasser
- Das Bügeleisen ist nicht warm genug
heraus
- Intensive Dampferzeugung
- Kondenswasser im Verbindungsschlauch
- Andere Ursachen
Das Gerät macht ein untypisches
- Es ist kein Wasser im Behälter
Geräusch
- Der Wasserbehälter ist nicht richtig befestigt
Dampferzeuger macht ein
- Es befindet sich ein wenig Wasser im
klatschendes Geräusch
Dampferzeuger
Wasserbehälter läßt sich nicht
-- Die Filterkartusche wurde nicht richtig eingesetzt - Behälter herausziehen und Filterkartusche richtig einsetzen
ins Gehäuse hineinsteckens
LÖSUNGEN
- Steckverbindung und Stromversorgung kontrollieren
- Gerät zum Händler bringen
- Den Regler aufdrehen
- Gerät zum Händler bringen
- Wasserbehälter auffüllen
- Behälter fest in sein Gehäuse drücken
- Kalkfilter-Kartusche in den Behälter einsetzen
blinkt
- Kalkfilter-Kartusche wechseln
- Gerät zum Händler bringen
- Stellen Sie den Thermostat auf
●●
- Warten, bis die Dampferzeuger-Kontrolllampe ausgeht
- Dampfstoßtaste mehrmals drücken
- Gerät zum Händler bringen
- Wasserbehälter nachfüllen
- Behälter fest in sein Gehäuse drücken
- Keine Gefahr.
Substances contained in fabrics such as cleaning product residues and thread
particles may eventually stain the plate of the iron. So if necessary, after ironing
rub the plate while it is still warm using a good quality cloth (one which does not
leave any traces of fluff) or clean it more thoroughly with an iron-cleaning stick.
Do not use scouring powders, alkalines (as used with ovens), abrasives or steel
wool.
Please make sure that the soleplate is kept clean at all times to
maintain the iron's gliding capacity.
PROBLEMS
CAUSES
None of the lights
- Power supply problem
are lit.
- Other
The iron does not
- Thermostat switch on Mini
heat up.
- Other
No steam is
- The container is empty
produced.
- The container is incor-rectly inserted or has not been inserted.
- The anti-scale cartridge has not been inserted
- The pilot light
- Other
Water is produced
- The plate of the iron is not hot enough
●●●
with the steam.
- Intensive use of steam
- Water condensation in the tube
- Other
The machine makes
- There is no more water in the container
a noise.
- The container is incorrectly inserted or has not been inserted.
The machine makes
- A small amount of water is left in the steam generator
a clicking noise
The water container
- The anti-scale cartridge is the wrong way round or has not
cannot be inserted.
been correctly inserted
- 20 -
MAINTENANCE
WHAT TO DO IF...
SOLUTIONS
- Check the plugs and mains
- Go to your local dealer
- Turn the switch
- Go to your local dealer
- Fill the container
- Insert the container and push it right to the bottom
- Insert a anti-scale cartridge in the container
flashes
- Change the anti-scale cartridge
- Go to your local dealer
- Put the switch to the
- Wait for the steam generator light to go out.
- Press the steam button several times
- Go to your local dealer
- Fill the container
- Insert the container and push it right to the bottom
- No danger
- Remove the container and check that the anti-sediment
cartridge has been correctly inserted
●●
●●●

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Xelys 2Xelys 3

Table des Matières