R&G CP0244BL Instructions

FITTING INSTRUCTIONS FOR CP0244BL/WH CRASH PROTECTORS
TOWARDS REAR
OF BIKE
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
Left-hand side (as you sit on bike)

Remove front side fairing.

Loosen the engine bolt arrowed above left, undo the bolt until head of bolt just contacts inside
edge of fairing when the fairing is refitted.

Paint the head of the bolt with paint or tippex and refit fairing.

Ensure paint has marked the inside face of fairing and remove fairing.

Using pilot drill from a 28mm tank cutter, drill fairing from inside face of fairing central to paint
mark from head of bolt.

Refit fairing to ensure pilot hole is central to engine bolt.

Remove fairing and using pilot hole as guide drill fairing using 28mm tank cutter.

Remove engine bolt ensuring frame to engine spacer does not move (if the spacer is very loose a
dab of super glue on the face may hole it in position).

Refit the fairing.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
YAMAHA YZF-R1 2009-
R&G Racing
www.rg-racing.com
TOWARDS FRONT
OF BIKE
Email: info@rg-racing.com