Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FITTING INSTRUCTIONS FOR CP0237BL CRASH PROTECTORS
KAWASAKI NINJA 250R 2008-
TOWARDS REAR
TOWARDS FRONT
OF BIKE
OF BIKE
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber
washers should be thrown away!
You will need the following tools to complete this job.
Set off metric allen keys.
Socket set to include 17mm, 14mm and 15mm A/F socket and wrench.
14mm and 17mm spanner.
Torque wrench to be used at 40NM.
Roll of electrical tape if required.
R&G Racing
Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
Manuels Connexes pour R&G CP0237BL
Sommaire des Matières pour R&G CP0237BL
- Page 1 FITTING INSTRUCTIONS FOR CP0237BL CRASH PROTECTORS KAWASAKI NINJA 250R 2008- TOWARDS REAR TOWARDS FRONT OF BIKE OF BIKE Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike Please note that in cases where kits are packed with rubber washers holding the components onto the bolt – the rubber washers should be thrown away! You will need the following tools to complete this job.
- Page 2 PICTURE 1 RECTIFIER PICTURE 2 R&G Racing Unit 5K, Blacknest Industrial Park, Blacknest Road, Alton, Hampshire, GU34 4PX Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101 www.rg-racing.com Email: info@rg-racing.com...
- Page 3 Left-hand side (as you sit on bike) Remove left and right-hand side fairings as shown in picture 1 and 2.(you will have to disconnect indicators). Undo and remove the engine bolt arrowed and labelled C and F (gently knock out with new engine-bar from kit using soft mallet).
- Page 4 Offer assembly up to right hand extension (there is an threaded insert located in the extension so the bolt will not engage until bolt is entered by approximately 25mm). Tighten bolt until you feel some compression from inside the protector. PLEASE NOTE BOBBIN MUST BE POSITIONED AS PICTURED ABOVE WITH BIGGER END TOWARD FRONT OF BIKE.
- Page 5 FRANCE INSTRUCTIONS DE MONTAGE DES PROTECTIONS CP0237BL KAWASAKI NINJA 250R 2008- ’ ’ R&G A PRESENTATION DES PIECES DANS L EMBALLAGE N EST PAS TOUJOURS IDENTIQUE AU SENS DE MONTAGE Merci de noter que dans le cas où les protections sont assemblées avec une bague en caoutchouc, merci de bien vouloir le retirer lors du montage des pièces sur la moto.
- Page 6 Pour la fixation de la patte ->inférieure, vous devrez utiliser l’écrou et la rondelle livrées dans le kit pour la fixer à l’axe R&G précédemment monté (repère C et F). ->supérieur, utilisez les deux vis et serrer à l’aide des écrous d’origine. ...