Olympus PT-030 Mode D'emploi page 61

Insertion of silica gel
Before sealing the Case,
insert the accessory silica
gel bag (for prevention of
fogging) between
bottom of the camera and
the Case. Insert the bag
with the glued longer side
to the inside.
CAUTION
: • Insert the silica gel all the way at the specified
location and with the specified orientation. When the
orientation is not correct, the silica gel bag will be
caught when the Case is sealed and water leakage
will be caused.
• Attempting to seal the Case with the bag inserted only
part of the way will cause the silica gel bag to get caught
by the O-ring and water leakage will occur.
• Once silica gel has been used, the moisture
absorption performance will be impaired. Always
exchange the silica gel when the Case is opened and
closed.
Set the mode dial.
After closing the rear lid of the
Case, fit the Case's mode dial
(located on the front lid of the
Case,) over the top of the digital
camera's mode dial.
Advice • After fitting the Case's mode dial knob, turn the knob to
make sure that the camera's mode dial switches before
closing the Case tightly.
• If the camera's mode dial does not turn when turning the
mode dial knob, gently push in the knob while turning it.
the
Pay attention to the orientation.
E-20
Mode dial
knob