Solving Problems - Beko HCA62320W Mode D'emploi

Solving problems

7
Symptoms
During hood operation, the pulsating
letter „F" is displayed.
The display shows only the symbol
"-." (minus and dot in the right bottom
corner), the hood does not respond to
disabling.
No symbol is shown on the display, the
hood does not respond to pressing the
control fields.
The display shows the symbol of one of
the gears; the hood does not respond to
pressing the control fields.
The hood turbine disconnects after 15
min of operation, the display shows
a pulsating digit i.e. "1." (current gear
number and dot in the right bottom
corner).
On fourth gear the digit "4" is pulsating
on the display, after 5min the gear is
changed into third.
The hood can be operated only with
use of the control panel, it does not
respond to the remote control.
The hood has very poor vapor suction.
One or more light points do not
operate.
The hood generated excessive noise
and vibration.
If the recommendations above do not solve the problem, contact an authorized home appliances service entitled to repair.
Under no circumstances is the hood user entitled to independent repair. A list of service points is included in the warranty card
and the website.
20 / EN
Cause
After 35 hours of operation the hood
indicates the need for cleaning or
replacing the grease filter.
The touch control has been locked
– this feature facilitates the hood
cleaning.
The touch control is probably
suspended.
The touch control is probably
suspended
The automatic time switch of the
touch control has been activated.
The hood is equipped with a turbo
mode, which automatically switches
over into third gear after 5 min of
operation to save energy.
The battery of the remote control is
empty or the distance is too long.
Probably cause is dirty filters.
Defective halogen/ LED bulb.
This may be caused by an incorrect
installation of the hood to the wall
or kitchen cabinets. Not all provided
screws have been used or screws are
loosely fitted leaving clearance.
* applies to hoods with touch control.
Repairing method
Press and hold for about 8 sec. "-" on
the touch control. The filter should be
washed in the dishwasher or replace with
a new one.
To disable the lock, press and hold for
about 10 sec the field with the symbol of
switching on.
Disconnect the hood from the power
supply for about 15 sec. and switch it on
again.
Disconnect the hood from the power
supply for about 15 sec. and switch it on
again.
To deactivate the time switch, press and
hold for about 10 sec the symbol „+"or
disable the hood.
The turbo gear shall be used only with
intensive cooking.
Replace the battery with a new one.
The grease filter must be cleaned in the
dishwasher or replace with a new one.
The carbon filter (if present) must be
replaced with a new one.
The light bulb needs to be replaced
with a new, compatible with the symbol
specified in the instruction manual for
the cooker hood.
The hood must be mounted to a wall or
cabinet by using all the points provided
for by the manufacturer. After adjusting
the position of the hood horizontally and
vertically, tighten all mounting screws.
Hood / User Manual