Installation Procedure; Installing The Supply Holder Unit; Connecting The Power Cord And Cables - Toshiba TEC B-450-QP Série Mode D'emploi

6. INSTALLATION PROCEDURE

6. INSTALLATION PROCEDURE

6.1 INSTALLING THE SUPPLY HOLDER UNIT

Turn the power OFF before installing the supply holder unit.
Fit the two studs on the bottom of the printer into the holes in the supply holder unit.
Supply Holder Unit

6.2 CONNECTING THE POWER CORD AND CABLES

Turn the POWER SWITCH to OFF before connecting the power cord or cables.
WARNING!
WARNING!
Power Cord
E6-1
ENGLISH VERSION EO1-33005
6.1 INSTALLING THE SUPPLY HOLDER UNIT
Fig. 6-1
Parallel Interface Cable
(Centronics)
Serial Interface Cable
(RS-232C)
Fig. 6-2