Installation Procedure; Holder Stand Installation; Connecting The Power Cord And Cables - Toshiba TEC B-670 Série Mode D'emploi

6. INSTALLATION PROCEDURE

6. INSTALLATION PROCEDURE

6.1 CONNECTING THE POWER CORD AND CABLES

Turn the POWER SWITCH to OFF before connecting the power cord or cables.
Expansion I/O
Cable
4
1
NOTES: Different cables cannot be used at the same time.

6.2 HOLDER STAND INSTALLATION

Fit the left and right side holders into the dowels of the holder base and fasten the side holders to the
holder base with the thumbscrews.
Left Side Holder
Holder Base
[B-672]
3
2
1 Power Cord
2 Serial Interface Cable (RS-232C)
3 Parallel Interface Cable (Centronics)
4 Expansion I/O Cable
Dowel
6.1 CONNECTING THE POWER CORD AND CABLES
WARNING!
1
2
3
Thumbscrew
E6-1
ENGLISH VERSION EO1-33016
[B-682]
4
Fig. 6-1
Right Side Holder
Fig. 6-2