Inserting The Optional Flash Memory Card - Toshiba TEC B-670 Série Mode D'emploi

9. INSERTING THE OPTIONAL FLASH MEMORY CARD

9. INSERTING THE OPTIONAL FLASH MEMORY CARD
(B-672 only)
Turn the power OFF when inserting or removing the flash memory card.
CAUTION:
To protect memory cards, discharge static electricity from your body by touching the printer rear
cover prior to touching the memory cards.
1. Turn the power off.
2. Insert the flash memory card into the memory card slot on the rear of the printer.
3. Turn the power on.
NOTES: 1. Be sure to protect a flash memory card when not in use in the printer by putting it in it's
protective cover.
2. Do not subject the card to any shocks or excessive forces.
3. Do not expose the card to extremes of heat by either storing in direct sunlight or close to
a heater.
4. Do not expose the card to excessive humidity by wiping it with a wet cloth or storing it in
a damp place.
5. Before inserting or removing the card, make sure that the power switch is turned off.
6. The following flash cards can be used. (The 1MB-card is read only and the 4MB card can
read/write.)
Capacity
1M Byte
4M Byte
Flash Memory Card
Maker
Maxell
Mitsubishi
Maxell
Maxell
Centennial Technologies INC.
INTEL
Simple TECHNOLOGY
Mitsubishi
PC Card KING MAX
PC Card
9. INSERTING THE OPTIONAL FLASH MEMORY CARD
WARNING!
Type
EF-1M-TB AA
MF81M1-GBDAT01
EF-4M-TB CC
EF-4M-TB DC
FL04M-15-11119-03
IMC004FLSA
STI-FL/4A
MF84M1-G7DAT01
FJN-004M6C
FJP-004M6R
E9-1
ENGLISH VERSION EO1-33016
Fig. 9-1
Maker code
Device code
1CH
D0H
B0H
88H
04H
ADH
01H
89H
A2H
89H
A0H