Toshiba TEC B-670 Série Mode D'emploi page 2

LIST OF STANDARDS OF CONFORMITY
Manufacturer
Address
Product Name
Model
Options
Generic Standard
Safety
EMC
Harmonics
Supplementary Information
The product herewith complies with the requirements of the Low Voltage Directive 73/
23/EEC, and the EMC directive 89/336/EEC.
The product was tested in a typical set up TOSHIBA TEC personnel advocated.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operations of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by manufacturer for compliance could void the
user's authority to operate the equipment.
"This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations."
"Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel
brouilleur de Canada."
: TOSHIBA TEC Corporation
: 570 Ohito, Ohito-Cho, Tagata-Gun, Shizuoka-Ken, 410-2323
Japan
declares that following product
: Bar Code Printer
: B-672-QP, B-682-QP
: All
conforms to the following product specifications
: EN 50 082-1
: EN 60 950
: EN 55 022
: EN 61000-3-2, 3
(for USA only)
(for CANADA only)
Copyright © 2000
by TOSHIBA TEC CORPORATION
All Rights Reserved
570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN