Toshiba TEC B-450-QP Série Mode D'emploi page 17

8. LOADING THE PAPER
3. Put the paper roll and supply holders on the supply holder unit.
NOTE: Paper may be wound outside or inside. Regardless of the paper roll, the paper must be loaded
so that the print side faces upward.
4. Push both sides of the supply holder guides against the paper roll, then lock them with the lock lever.
NOTE: Make sure that the supply holders rotate slightly.
5. Pass the paper through the printer until it is past the paper outlet.
6. Adjust the position of the paper guides to the paper width, then lock them with the lock lever.
Paper Guide Lock Lever
Supply Holder Guide
7. Close the print head block by pressing both sides of the print head block's top until it clicks.
Head Block
Paper wound inside.
Paper Guide
Lock Lever
E8-2
Paper wound outside.
ENGLISH VERSION EO1-33005
8. LOADING THE PAPER
Fig. 8-4
Paper Roll
Supply Holder
Fig. 8-5
Fig. 8-6