Barrette BOL-WEB Instructions D'installation page 4

Installing Gate Uprights
2.
a. Install the now cut panel in one of the gate
uprights.
b. Rack the panel at the desired angle and push
the panel to the back of the upright (A) to where
there is no gaps (Fig. 5).
c. Using two clamps, clamp the gate and upright
together from the back of the rst picket to
the back of the upright (Fig. 6). This will help
in preventing the panel from moving in the
following steps.
3.
Take the two Rail Grippers (F1) in your Hardware
Bag and install them on both sides of the rail
inside of the upright brackets (Fig 7).
4.
Using a
rail using the two pre-drilled holes on the rail
grippers. If your gate width has a picket between
the slots (Fig. 8) drill thought the picket as well.
4
⁄ ⁄ " drill bit, drill a hole all the way through ⁄ ⁄
1 1 1
4 4
Top view of gate upright Top view of gate upright
Gate Upright Gate Upright
Panel Panel
F1 F1
Slide F1 under Slide F1 under Slide F1 under Slide F1 under Slide F1 under
Drill Here Drill Here
Fig. 5
No gap No gap
Fig. 6
Clamp Clamp
Clamp Clamp
Fig. 7
bracket bracket
Fig. 8