1. GENERAL INFORMATION
The distance between the remote controller and the indoor unit should be within
7m and without any obstacle.
The presence of an electronic-starter fluorescent lamp or a wireless telephone
in the room can interfere with the reception of the signal by the receiver. It is
advised to reduce the distance between the signal transmission head and the
receiver hole.
Full display or unclear display during operation indicates that the batteries need
to be changed.
If the remote controller does not operate normally, remove the batteries and
reload several minutes later.
Intake grill
Air outlet
(To adjust the up-down airflow)
Display board
1.
Signal receiver.
2.
Setpoint temperature display.
3.
Operation mode indicator (the indicator is ON when the compressor is operating).
4.
Wi-Fi (option).
32
OPERATION MANUAL
Air inlet
Louvers
1
2
Air filter (inside)
4
3
Wi-Fi module port
(Option)
Emergency/Power on switch
Display board