EUFAB 12015 Instructions De Montage page 2

GB
Art. No. 12015
ALU STAR
Deadweight of the cycle rack: 2.8 kg
Assembly instructions
Mount the hand wheel B to the tubular bracket using the screw G and the spring D. The cycle rack
should be mounted to the front support bar using the enclosed U-bracket U. Mount the cycle rack
to the roof support. Mount the cycle rack to the rear support. Push the T-slide L into the bottom of
the profile rail. Place the cycle rack onto the roof support and align. Use the assembly plate and
the toggle nuts to attach the cycle rack. Place the clamp jaws of the tubular bracket to the front
sloping frame part of the cycle and tighten using the hand wheel B. Attach pivot screw C using the
lockable tog nut. Tighten the wheels in the profile rail using the holding straps H.
Safety information:
Check the screws for the first time after driving a short distance and then at regular intervals.
Please note that the load on the roof will change the driving properties of your vehicle during brak-
ing, in the case of side winds and when driving round bends. Adjust your driving speed according-
ly. In particular, observe the information provided by the manufacturer of the vehicle about the
permitted roof loads. Parts of the cycles, such as e.g. handlebars or pedals, should not protrude
over the edge of the roof. If not needed, the cycle rack should be dismantled for reasons of safety
for other road users and economy (petrol consumption). CAUTION: When the cycle is mounted,
note the greater height of your vehicle when entering underground car parks, tunnels etc. Before
setting off on your journey, always check that the attachments are all correct. IMPORTANT: Al-
ways use the supplied holding belt. Deadweight of the cycle rack: 2.8 kg
2