Accessories; Noise Information; Vibration Information - Worx WG583E Mode D'emploi

ACCESSORIES

Battery pack
Charger
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K :
pA wA
Wear ear protection

VIBRATION INFORMATION

14
Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
Cordless Blower/Vac/Mulcher
WG583E WG583E.9
2 (WA3553) /
1 (WA3883) /
L : 84.7 dB(A)
pA
L : 99.7 dB(A)
wA
3 .0 dB(A)
a <2.5 m/s
h
K=1.5 m/s2
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATION
INTENDED USE:
The blower & Vac is intended for residential use only.
Use the blower outdoors to move or vacuum yard
debris as needed.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Checking the battery condition
NOTE: Fig. A only applies for the battery
pack with battery indicator light.
2
Charging the battery pack
NOTE:
• The batteries are shipped un-
charged. Each battery must be fully
charged before the first use.
• Always fully charge the two batteries
at same time. More details can be
found in charger's manual.
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices.
Never insert or allow metallic
objects into your charger or battery
pack connections because of an
electrical failure and hazard will
occur.
Installing and Removing the battery pack
NOTE:
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
• When you use two batteries with
different power,the machine will
only run to the level of the lowest
charged battery
FIGURE
See Fig. A
See Fig. B
See Fig.C
EN