Fuel Safety - Husqvarna 135R Manuel D'utilisation

A locknut is used to attach some types of cutting
attachments. The locknut has a left hand thread.
• To install the locknut, turn the locknut in the opposite
direction from the direction of rotation.
• To remove the locknut, remove the locknut in the
direction of rotation.
• To loosen or tighten the locknut, use a socket
wrench with a long shaft.
WARNING:
tighten the locknut there is a risk of injury
from the cutting attachment. Be careful
and do not touch the cutting attachment.
Note:
Make sure that you can not turn the locknut
by hand. Replace the locknut after it has been put on
approximately 10 times. The locknut must be replaced
after it has been put on approximately 10 times.
Cutting attachment
WARNING:
instructions that follow before you use the
product.
• Do the regular maintenance. Let an approved
service center regularly examine the cutting
attachment to do adjustments or repairs.
• The performance of the cutting attachment
increases.
• The life of the cutting attachment increases.
• The risk of accidents decreases.
• Only use an approved cutting attachment guard.
Accessories on page 25 .
Refer to
• Do not use a damaged cutting attachment.
Grass trimmer head
• Make sure that you wind the grass trimmer line
tightly and equally around the drum to decrease the
vibration.
• Use only the approved grass trimmer heads and
grass trimmer lines. Refer to
page 18 .
975 - 005 - 14.11.2022
When you loosen and
Read the warning
To trim the grass on
• Use a correct length of the grass trimmer line. A long
grass trimmer line uses more engine power than a
short grass trimmer line.
• Make sure that the cutter on the cutting attachment
guard is not damaged.
• Soak the grass trimmer line in water for 2 days
before you attach the grass trimmer line to the
product. This increases the life of the grass trimmer
line.
• Refer to the instructions for the cutting attachment to
use the correct procedure to load the cord and the
correct cord diameter.
Grass blade
• Use correctly sharpened blades. An incorrectly
sharpened or damaged blade increases the risk
of injury. Refer to the instructions on the blade
packaging.
• Use correctly set blades. An incorrectly set blade
increases the risk of injury and damage.

Fuel safety

WARNING:
instructions that follow before you use the
product.
• Do not mix the fuel indoor or near a heat source.
• Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and
let the product dry. Remove unwanted fuel from the
product.
• If you spill fuel on your clothing, change clothing
immediately.
• Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use a soap and water to
remove the fuel.
• Do not start the engine if you spill oil or fuel on the
product or on your body.
• Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
• Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
• Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is sufficient airflow.
• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before you refuel.
• Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
• Make sure there are sufficient airflow when refueling
and mixing fuel (petrol and two-stroke oil) or draining
the fuel tank.
• Fuel and fuel vapor are highly flammable and can
cause serious injury when inhaled or allowed to
come into contact with the skin. For this reason,
Read the warning
9