Husqvarna 135R Manuel D'utilisation page 12

6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade.
7. Attach the nut (G).
8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To install the blade guard
CAUTION:
guard for the blades. Refer to
on page 25 .
1. Remove the bracket (H).
2. Attach the adapter (I) and bracket (J) with the 2
screws (K).
3. Attach the blade guard (A) to the adapter with the 4
screws (L).
H
12
Only use the approved
Accessories
J K
I
L
A
To assemble the guard and trimmer head/
plastic blades
CAUTION:
extension is assembled.
1. Install the trimmer guard/cutting attachment guard
(A) intended for operation with the trimmer head/
plastic blades.
2. Hang the trimmer guard/cutting attachment guard (A)
on the two hooks on the plate holder (M).
3. Bend the guard around the shaft and tighten it with
the bolt (L) on the opposite side of the shaft. Use the
locking pin (C).
4. Put the locking pin in the groove on the screw head
and tighten.
M
A
5. Install the drive disc (B) on the output shaft.
H
B
C
M
6. Turn the output shaft until 1 of the holes in the drive
disc aligns with the related hole in the gear housing.
7. Put the locking pin (C) in the hole to lock the shaft.
Make sure that the guard
L
C
A
L
975 - 005 - 14.11.2022