Husqvarna 135R Manuel D'utilisation page 20

Maintenance
Examine the cutting attachment guard for damages and cracks.
Make sure that the grass blade is aligned with the center. Make sure that the
grass blade is sharp and that the blade or center hole is not damaged.
Examine the trimmer head for damages and cracks. Replace if it is damaged.
Examine the handle and handlebar for damage and make sure that they are
attached correctly.
For cutting attachments with a support cup, tighten the locking screw fully.
For cutting attachments with a locknut, tighten the locknut fully.
Examine the transport guard for damage and make sure that it can be attached
correctly.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the air filter. Replace if it is necessary.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
Examine all cables and connections.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages and cracks.
Examine the spark plug. Refer to
Clean the cooling system.
Make sure that the bevel gear is filled to ¾ with grease.
Clean the external surface of the carburetor and the area around it.
Clean the spark plug. Remove the spark plug and do a check of the electrode
gap. Adjust the electrode gap to 0.5 mm or replace the spark plug if it is neces-
sary. Make sure that the spark plug is assembled with a supressor.
Clean or replace the spark arrestor mesh on the muffler.
Examine the clutch, clutch springs and the clutch drum for wear. Replace if it is
necessary.
Replace the spark plug. Make sure that the spark plug is assembled with a
supressor.
Lubricate the drive shaft.
Make sure that the safety release on the harness is not damaged and operates
correctly.
Examine and clean the spark arrestor mesh on the muffler.
To adjust the idle speed
Your Husqvarna product is made to specifications that
decrease harmful emissions.
1
At an interval of 6 months.
20
To do a check of the spark plug on page 23 .
1
1. Make sure that the air filter is clean and that the air
filter cover is attached to the product.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
975 - 005 - 14.11.2022
X
X
X
X
X