Next Level Racing FGT ELITE LITE Manuel D'instructions page 8

support@nextlevelracing.com
( )
T-Nut Locations
13 Install 1 x T-Nut into the front inner channel and 1 x T-Nut into the rear inner channel of the Left and
Right Wheel Posts.
NOTE: Use level provided. Wheel Deck must be kept
flat and level during installation to avoid skewing.
Felt pads
14
Remove protective layer on the Sticky Felt Pads and stick them on to the Wheel Deck to prevent scratching when adjusting.
Align the Wheel Deck with the T-Nuts previously installed in Step 13. Bolt through and secure with 4 x M8 Bolts and Washers.
WHEEL DECK ADJUSTMENT
Loosen the Bolts securing the Wheel Posts to the Base Assembly. Adjust to the desired position and tighten the
15
Bolts to lock in place. Loosen the Bolts securing the Wheel Deck to the Wheel Posts. Adjust to the desired height
and angle using the alignment lines as a guide. Tighten the Bolts to secure the Wheel Deck in place.
14
PARTS:
• • 4 x T-Nuts
16
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • Wheel Deck
• • 2 x 90x10mm Felt Pad
17
PARTS:
• • NIL
(
PRE-DRILLED HOLE
(
RIGHT
18
( )
T-Nuts Location
( )
T-Nuts Location
Install 2 x T-Nuts into the front channel of the Left and Right Wheel Posts.
Repeat
on Other
Align the mounting holes on the Pedal Arm Brackets with the T-Nuts previously installed in Step 16.
Bolt through and secure with 4 x M8 Bolts and Washers.
INSIDE VIEW
( )
PRE-DRILLED HOLE
( )
LEFT
)
)
Install 4 x T-Nuts into the top channel and 1 x T-Nut into the inside channel of the Left Pedal Arm.
Repeat the same steps for the Right Pedal Arm.
15
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x T-Nuts
Repeat
on Other
Side
PARTS:
• • 4 x M8 16mm Bolts
Side
• • 4 x M8 Washers
• • 2 x Pedal Arm Brackets
PARTS:
TOP VIEW
• • 10 x T-Nuts
• • 2 x Pedal Arms