Next Level Racing FGT ELITE LITE Manuel D'instructions page 10

support@nextlevelracing.com
GT PEDAL POSITION
(Skip to Step 28 to continue)
A) Remove the Bolts and Washers holding the Left and RIght Base to the Rear Base.
24
B) Uninstall 1 x T-Nut from the top outer channel of the Left and Right Base.
A) Install 1 x T-Nut into the bottom outer channel of the Left and Right Base.
25
B) Re-install the Bolts and Washers removed in Step 24.
26
Align the Pedal Adjustment Fins mounting holes with the T-Nuts previously installed in Steps 01a, 01b
and 25. Bolt through and secure with 4 x M8 Bolts and Washers.
PARTS:
• • NIL
A)
B)
PARTS:
• • 4 x M8 40mm Bolts
B)
• • 4 x M8 Washers
• • 2 x T-Nuts
A)
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Pedal Adjustment Fins
18
27
Align the adjustment slot on the Pedal Adjustment Fins with the T-Nuts previously installed in Step 18.
Bolt through and secure with 2 x M8 Bolts and Washers.
A) B)
( )
Butt-Kicker T-Nuts location
( )
Felt Pads location
A) Install 2 x T-Nuts into the bottom channel of the Front Seat Slider and 2 x T-Nuts into the top channel of both Seat Sliders, Install 2 x 35mm x
28
40mm Felt Pads at the marked locations on the bottom of the both Seat Sliders.
B) Align the Seat Slider End Plates with the threaded holes on the Seat Sliders. Bolt through and secure with 4 x M8 Countersunk Bolts.
A) B)
29
A) Align the holes on the Buttkicker Mount Pole with the T-Nuts previously installed in Step 28.
B) Bolt through and secure with 2 x M8 Bolts.
19
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
• • 2 x Seat Sliders
• • 4 x Seat Slider • • 4 x M8 Counter
End Plates sunk Bolts
• • 4 x Sticky Felt Pads
(35mm x 40mm)
• • 6 x T-Nuts
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers