Next Level Racing FGT ELITE LITE Manuel D'instructions page 11

support@nextlevelracing.com
30 Align the front Seat Slider Assembly with the T-Nuts previously installed in Steps 01a and 01b.
Bolt through and secure with 2 x Ratchet Handles.
31 Align the rear Seat Slider Assembly with the T-Nuts previously installed in Steps 01a and 01b.
Bolt through and secure with 2 x Ratchet Handles.
32
Align the Seat Brackets slots with the T-Nuts previously installed in Step 28.
20
PARTS:
• • 2 x Seat Sliders Ratchet Handles
Repeat
on Other
Side
PARTS:
• • 2 x Seat Sliders Ratchet Handles
Repeat
on Other
Side
PARTS:
• • 2 x Seat Brackets
33
Bolt through and secure with 4 x M8 Bolts and Washers.
OPTIONAL OVER HANGING
SEAT BRACKET SETUP
(USERS 180cm or TALLER)
Align the Seat Brackets mounting slots with the T-Nuts previously installed in Step 28.
34
Make sure the Seat Brackets are aligned in the furthest rear position.
Bolt through and secure with 4 x M8 Bolts and Washers.
35
Install 2 x T-Nuts in the front and rear outside channels of one of the Wheel Posts. Align the mounting holes on
the Tool Kit Holder with the T-Nuts. Bolt through and secure with 2 x M8 Bolts and Nylon Washers.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
PARTS:
• • 2 x Seat Brackets
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Nylon Washers
• • Tool Kit Holder
21