Oase Vitronic 11 Notice D'emploi page 15

Safe operation
• Never operate the unit if either the electrical cables or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
• Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical modifications to the unit.
• The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
• Only operate the unit if no persons are in the water!
• The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
• Keep the socket and power plug dry.
Installation and connection
Prerequisite
• The unit head is removed. (→ Removing the unit head)
Set-up the unit
How to proceed:
B, C
• Install the unit at least 2 m from the edge of the pond.
• Only install the unit in the permitted positions to ensure fault-free operation.
• Allow sufficient space for carrying out maintenance work.
Connect the unit
Use hoses that are suitable for a pressure of at least 1 bar.
How to proceed:
D
1. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
2. Connect the hose with the stepped hose adapter and secure with a hose clip.
– In the case of a stepped hose adapter with separate union nut, first push the union nut over the hose.
3. Connect the stepped hose adapter with seal to the casing.
– Connect the inlet and outlet.
– Hand tighten the stepped hose adapter.
Connect the unit to the flow-through filter.
Vitronic 18 W / 24 W / 36 W
The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to the inlet nozzles on the
flow-through filter. Adhere to the instructions for use of the flow-through filter.
How to proceed:
E
1. Unscrew the cover cap.
2. Guide the outlet sockets with flat seal through both holes in the container wall of the flow-through filter.
3. Screw the inlet nozzle with O ring onto the outlet socket and hand tighten.
4. Connect the supply hose to the inlet socket. (→ Establish connections)
- EN -
15