Publicité
Instructions for use with a PBX system
All manuals and user guides at all-guides.com
If the telephone is connected to a PBX
system, you must program the trunk access
codes before you can use the telephone.
The telephone will automatically insert a
pause after the access code so that it will
not be necessary to interrupt dialing to wait
for the CO dial tone. A maximum of two
access codes, each having one or two
digits, can be programmed.
Programming one access code:
Lift the handset
Press the PROG key
Press the number 0
: Enter the access code (1 or 2 digits)
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
Programming two access codes:
Lift the handset
Press the PROG key
Press the number 0
Enter the first access code (1 or 2
:
digits)
Press the REDIAL key
Enter the second access code (1 or 2
:
digits)
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
Erasing the programmed access codes:
Lift the handset
Press the PROG key
Press the number 0
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
Setting the handset volume
This telephone allows you to adjust the
handset volume. By default, the volume is
set to normal volume. To select the desired
volume, proceed as follows:
Lift the handset
Press the PROG key
Enter one of the codes below,
depending on the desired option:
• 91 normal volume
:
• 92 high volume
Press the PROG key
Listen for the confirmation tone (long
beep)
Replace the handset
Password
The key lock function is protected by a 4-
digit password. The default password is
1234 and can be changed.
Changing the password:
Lift the handset
Press the PROG key
Press the
: Enter the password (4 digits)
: Enter the new password (4 digits)
6
key
Publicité
