Joerns Oxford Elevate Manuel De L'utilisateur page 24

Masquer les pouces Voir aussi pour Oxford Elevate:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Oxford
®
Elevate
A 9-volt battery powers the Oxford Electronic Digital Scale. A new battery should provide
approximately 3000 readings before needing replacement. When it needs to be replaced, a "B" will
appear on the display.
To Replace Battery
1. Push black pad on bottom of unit to left.
2. Battery holder will slide out.
3. Remove old battery and replace with a new one.
4. Push holder back into scale.
Operation Features
• All functions are accessible to the user without opening the case.
• Starting or zeroing the scale is done through a single touchpad located on the front of the case.
• Stable readings are achieved through digital averaging. The HOLD message is activated
when weight fluctuations decrease to a predetermined range. The scale becomes active again
when that range is exceeded. The held weight is stored in a non-volatile memory for later recall
if required.
• Display turns off after 60 seconds of inactivity to conserve battery life.
• Recall of the last held weight is available via a touchpad on the front of the case. This allows a
reading of the last patient's weight, after the patient has been removed from the scale.
• Battery change is made easy with external access to the battery holder.
Maintenance, Inspection and Test
Joerns Healthcare recommends that a thorough inspection and test of all Oxford lifts and
lifting accessories, slings etc. is carried out every six months. Joerns Healthcare recommends
maintenance, inspection and certified testing, is only carried out by competent and authorised
service dealers.
NOTE: These recommendations are in compliance with the requirements of 1998 No2307
Health and Safety: The Lifting Operations and Lifting Equipment Regulations 1998. This is a UK
regulation.
Outside the UK please check your local requirements.
Important Note (Europe Requirement Only)
The Oxford Weigh scale is a class 3 compliant weighing device and conforms to the NAWI
Directive 90/384/EEC and has been certified by the National Weights and Measures Laboratory.
NOTE: Scale is calibrated prior to shipment.
24
English

Publicité

Table des Matières
loading

Table des Matières