Wheel And Deck Zerks; Hydraulic Oil; Engine Oil - Husqvarna W548 Manuel D'utilisation

LUBRICATION

Wheel and Deck Zerks

Use only good quality bearing grease with a NLGI
grade No. 2 rating. Grease from well-known brand
names (petrochemical companies, etc.) usually
maintains a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
wheel mount.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck completely. Remove the
two spindle deck guards. Lubricate with a grease
gun, 2-3 strokes per spindle.

Engine oil

NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations and oil checking and changing
intervals.
Warning! The engine drain plug is
located close to the muffler. To prevent burns,
the engine should be shut off and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
1. Park on a level surface and engage the park
brake.
26
2. Clean the dirt and debris from the area around
the oil fill cap.
3. Locate the drain hose on the left side of the
engine below the dipstick.
4. Remove the hose from the storage clip
5. Place an sufficiently sized container under the
end of the drain and remove the oil drain plug.
6. Let the oil fully drain from the engine.
7. Replace the drain hose plug and tighten
securely.
8. Replace the hose into the storage clip.
9. Fill the engine with new oil to the bottom of
the fill tube threads. Check the level with the
dipstick.
10. Replace the oil fill cap securely when the oil
level is FULL.

Hydraulic Oil

Use 15W-50 synthetic motor oil or an equivalent.
Transmission Oil Level
1. Park on a level surface and engage the park
brake.
2. Remove the hydraulic reservoir cap; the oil
level should be 5" (12.7 cm) from the top of
the filler pipe. Add oil as needed.
Transmission Oil and Filter
1. Let the engine and hydraulic reservoir cool.
2. Clean the area around reservoir filler cap and
the oil filter mount.