Important - Jacuzzi Flexa Thema Square ST2 Notice D'installation

PLEASE READ THESE INSTRUCTIONS
CAREFULLY BEFORE INSTALLATION
Info
The FLEXA THEMA shower boxes are available in various versions.
For further information on teh functions featured on each individ-
ual model, please refer to the price list and the general catalogue.
All FLEXA THEMA models are, however, supplied in three separate
packages (shower tray+panel+top, glass panel set and fixture pan-
el) to make it easier for them to be taken into the place of installation.
For the ST2 model, the top is supplied as an optional, in separate
packaging to the shower tray.
IMPORTANT: when the goods arrive, check they are
intact, in order to lodge any necessary complaint
promptly against the forwarding agent.
I
These shower units must only be installed in corners (on tile fit-
ted walls and floors) without baseboards.
i
I
( 3-3a-3b ) For special maintenance (e.g. a broken pipe) it is
necessary to move the shower enclosure away from the wall. It is,
therefore, advisable to leave the indicated area free, or only keep it
for objects that are easy to move. Given the considerable weight of
the parts to be assembled, the assembly and installation of the show-
er enclosure must be carried out by two people.
Provision for plumbing and electrical connec-
tions
i
I
( )
4-4a-4b Provide a connection with the hot and cold water
supply (internal ø of supply pipes: minimum 14 mm).
The outlets (90° downward-facing pipe-fittings, 1/2" male couplings)
must be prepared in the wall and connected to the mixer unit (fit-
ted with female couplings), using the two 1 m 1/2" high capacity flex-
ible male-female hoses provided (internal ø 10 mm, 1 m long).
i
I
( 4-4a-4b ) In order to make installation easy, it is advisable
to prepare a wall drainage point (ø 40 mm) at floor level, as shown.
i
I
( 4-4a-4b ) A connection to the electric mains and to the earth
system must be made using an approved cable about 1.5 m long and
prepared as shown.
The ST2 model does not require connection to the electric mains.
If you wish to connect the ELT model to an alarm circuit, you will need
to prepare for its connection.
The proper functioning of the FLEXA THEMA shower enclosure re-
quires pressures to be balanced and a continuous supply of hot and
cold water. Pipes of adequate diameter must also be used, as indi-
cated in the "Plumbing specifications" table.
• If the water is very "hard", it is advisable to install a scale remover,
in order to prevent or reduce the formation of scale and to cut down
on the need for the scale removal cycle. The frequent use of the
steam bath also increases the formation of scale inside the boiler.
ATTENTION: (IEC 60335-1/A2) The pressure of the
water system that supplies the unit must not exceed
600 kPa (6 bar).
11