Publicité
Please read instructions carefully before installation.
Check the contents of kit. Contact your YAKIMA dealer if any parts appear missing or damaged.
Clean your Platform prior to installing the High Lift Jack Holder.
Place these instructions in the vehicle's glove box after installation is complete.
1
INSERT NUTS PLATES.
LOCKNLOAD BAR
INSTALLATION
Insert four M8 nut plates
into the crossbar channels
as shown. For LockNLoad
Bar slide them in sideways
and for HD Bar slide them
in lengthwise.
HD BAR
INSTALLATION
2
POSITION NUT PLATES IN CHANNELS.
Slide the M8 nut plates along channels so they are positioned
as close to the Platform edge/end of crossbars as possible.
The brackets can be used as a guide for spacing. Ensure nuts
are equally spaced at edge/end of crossbars. The hex wrench
can be used to assist nut movement within the channel.
PLATFORM
• PLATEFORME • PLATAFORMA
Instruction #09-13-592-Rev4 - Page 2 of 6
PLATFORM INSTALLATION
Insert four M8 nut plates into the
Platform sides and slats via the
cut outs as shown. Determine
the best slat spacing for the
high lift jack brackets based on
the length of Jack you will be
carrying. Note: The nut plates do
not need to be rotated into place.
LOCKNLOAD BAR
BARRE LOCKNLOAD
BARRA LOCKNLOAD
HD BAR
BARRE HD
BARRA HD
Publicité
